Kunnafoniw

How to Decontaminate the Accessories of the Vertical Machining Center

How to Decontaminate the Accessories of the Vertical Machining Center

2022-07-07 13:56:50

Vertical machining center refers to a machining center with the axis of the main shaft and the worktable set vertically. It is mainly suitable for machining complex parts such as plates, discs, molds and small shells. Three linkages, with the continuous development of technology, can also carry out five-axis and six-axis control.

 

During the processing and operation of the equipment, it is inevitable that dirt will be contaminated, and if it accumulates for a long time, it will form stubborn stains. Effectively cleans deposits without damaging parts. Let's take a look. Have you done the following decontamination methods right?

 

aluminum cnc service,water jet cnc machine,bar puller for cnc lathe

 

The first: scrub

 

Put the parts to be cleaned into a container filled with diesel, kerosene, or other cleaning fluids, and then scrub with cotton yarn, brushes, and other tools. This method is relatively simple to operate and the materials are very basic, but it is inefficient and labor-intensive and is generally only suitable for a single small part. It is important to note that you must not misuse gasoline to avoid injury.

 

The second: spray cleaning

 

The cleaning fluid with a certain pressure and temperature is sprayed strongly on the surface of the parts, and the oil stains are removed with the help of instant impact force. The advantage of this method is that the cleaning effect is much better than manual wiping, and the work efficiency is also greatly improved. The disadvantage is that it is only suitable for surface cleaning of flat parts, and parts with too complex structures are difficult to clean in place.

 

The third: ultrasonic vibration cleaning

 

Relying on the joint action of cleaning liquid and ultrasonic oscillation to remove oil pollution is the most time-saving and labor-saving cleaning method, and the cleaning effect is relatively obvious, but the cleaning cost is relatively high.

 

The fourth: cooking and washing

 

This method is simple and clear, which is to use the high temperature of the water to achieve the purpose of cleaning. Put the prepared solution together with the cleaned parts into a cleaning pool of appropriate size welded with steel plates, then heat it to 80~90℃ with the stove under the pool, and cook for 3~5 minutes. Although this method is simple to operate, it requires special cleaning pools and stoves, which is quite troublesome.

 

The cleaning methods mentioned above can be selected according to your needs. At the same time, due to the different nature of the parts, when choosing the decontamination method and decontamination agent, you cannot blindly pursue simple and low-cost and pay attention to the characteristics of the parts themselves according to a reasonable selection.

 

In addition, during the use of the machine tool, its comprehensive performance will change over time due to factors such as the environment, temperature, humidity, wear and tear of its parts, internal force deformation, and loss of wear parts. The existence of small problems may lead to the scrapping of the workpiece, and even endanger the accuracy and service life of the machine tool, so it is very necessary to do a good job of normal maintenance and inspection. Only solid maintenance and inspection can keep the machine tool in the best condition.

 

Conclusion

 

For more information about aluminum cnc service,water jet cnc machine,bar puller for cnc lathe, we are glad to answer for you.

Aw ye anw sɔrɔ
Tɔ̀gɔ

Tɔ̀gɔ can't be empty

* Email (Email) ci

Email (Email) ci can't be empty

Telefɔni

Telefɔni can't be empty

Cakɛda

Cakɛda can't be empty

* Bataki

Bataki can't be empty

Ka kolo